Toshiba W7 manual Frequency Mode #1, Frequency Mode #2, Terminal, Mode #1 Select

Frequency Mode #1				F Terminal
Frequency Mode #1
Program	Utilities Command and Frequency Settings Frequency			Parameter Type — Selection List
Mode #1 Select				Factory Default — Use RR
The Frequency Mode (#1) setting establishes the source of the frequency-				Changeable During Run — No
control input for the ASD.
Settings:
Use VI/II
Use RR
Use RX
Use Option Card RX2
Use LED Keypad Option
Use Binary/BCD Input
Use Common Serial (TTL)
Use RS232/RS485
Use Communication Card
Use Motorized Pot. Simulation
Use Pulse Input Option
Frequency Mode (#2)
Program	Frequency Settings Reference Priority		Frequency	Parameter Type — Selection List
⇒		⇒	⇒
Mode #2⇒		⇒	⇒	Factory Default — Use RR

This parameter selects the source of the frequency command signal to be used	Changeable During Run — No
as Frequency Mode #2 in the event that Frequency Mode #1 is disabled or if
Frequency Mode #2 is set up as the primary control parameter.
See the Reference Priority Selection parameter for additional information on
this setting.
The Frequency Mode setting establishes the source of the frequency-control
input for the ASD.
Settings:
Use VI/II
Use RR
Use RX
Use Option Card RX2
Use LED Keypad Option
Use Binary/BCD Input
Use Common Serial (TTL)
Use RS232/RS485
Use Communication Card
Use Motorized Pot. Simulation
Use Pulse Input Option

F Terminal

Program Terminal Settings Input Terminals F

This parameter⇒selects the functionality⇒of the F discrete⇒input terminal. In addition, the input terminal must be specified as Normally Open or Normally Closed.

This parameter sets the programmable F terminal to 1 of the 69 possible functions that are listed in Table 6 on page 138.

W7 ASD Installation and Operation Manual

Parameter Type — Selection List

Factory Default — Forward

Changeable During Run — No

75