Toshiba W7 manual Motor Capacity kW, Motor Constant #1, Motor Constant #2, Motor Constant #3

Motor Capacity (kW)						Motor Constant #4
Motor Capacity (kW)
Program	⇒	Motor Settings		⇒	Motor Capacity (kW)	Parameter Type — Numerical
						Factory Default — (ASD-dependent)
This user-input parameter identifies the wattage rating of the motor.
						Changeable During Run — No
						Minimum — 0.10
						Maximum — (ASD-dependent)
						Units — kW
Motor Constant #1
Program	⇒	Motor Settings		⇒	Motor Constant #1 (Primary resistance)	Parameter Type — Numerical
						Factory Default — (ASD-dependent)
This parameter is the measurement of the stator resistance and is considered a
Motor Constant (unchanging). This value is used in conjunction with other						Changeable During Run — No
constants to tune the motor.
To use Vector Control, Automatic Torque Boost, or Automatic Energy-						Minimum — 0.0
saving, the Motor Constant setting (motor tuning) is required.						Maximum — 100,000 MΩ
						Units — Ω
Motor Constant #2
Program		Motor Settings			Motor Constant #2 (Secondary	Parameter Type — Numerical
	⇒⇒
Resistance)						Factory Default — (ASD-dependent)
This parameter is the measurement of the rotor resistance and is considered a						Changeable During Run — No
Motor Constant (unchanging). This value is used in conjunction with other
constants to tune the motor.						Minimum — 0.00
This setting (motor tuning) is required to use the Vector Control, Automatic						Maximum — Open
Torque Boost, or Automatic Energy-saving functions.						Units — Ω
Motor Constant #3
Program		Motor Settings			Motor Constant #3 (Exciting	Parameter Type — Numerical
Inductance)						Factory Default — (ASD-dependent)
This parameter is used to input the excitation inductance for the motor. This						Changeable During Run — No
value is used in conjunction with other constants to tune the motor.
This setting (motor tuning) is required to use the Vector Control, Automatic						Minimum — 0.00
Torque Boost, or Automatic Energy-saving functions.						Maximum — 6500.0
						Units — µH
Motor Constant #4
Program		Motor Settings			Motor Constant #4 (Load Inertia)	Parameter Type — Numerical
This parameter is used to compensate for the affects of load inertia during speed						Factory Default — 1.0
changes.						Changeable During Run — Yes
Acceleration and deceleration overshoot may be reduced by increasing this						Minimum — 0.0
value.
This setting (motor tuning) is required to use the Vector Control, Automatic						Maximum — 100.0
Torque Boost⇒⇒, or Automatic Energy-saving functions.
W7 ASD Installation⇒			and Operation⇒Manual			85