
Commercial (Power) Wait Time |
|
| Communication Interval (TTL) | |||
|
|
|
| |||
Commercial (Power) Wait Time |
|
|
| |||
Program |
| Special Control Comm Wait Time | Parameter Type — Selection List | |||
This parameter determines the amount of time that the drive will wait before | Factory Default — 0.62 | |||||
allowing commercial power to be applied to the motor once the | Changeable During Run — No | |||||
|
| |||||
|
|
| ||||
|
|
|
|
| Minimum — 0.37 | |
|
|
|
|
| Maximum — 10.00 | |
|
|
|
|
| Units — Seconds | |
|
|
|
| |||
Communications Data Type |
|
|
| |||
Program |
| Communication Settings |
| Communication Data Type | Parameter Type — Selection List | |
In the event of a communication error during a transmission, the command that | Factory Default — 0 | |||||
was transmitted may be cleared or held. |
|
| Changeable During Run — No | |||
| ⇒ | ⇒ |
|
| ||
Changes made to this parameter require that the power be cycled (Off then On) |
| |||||
for the changes to take effect. |
|
|
| |||
Settings: |
|
|
|
|
| |
0 — Command Request Cleared |
|
|
| |||
1 — Command Request Held |
|
|
| |||
|
|
|
| |||
Communication Interval (TTL) |
|
|
| |||
Program | ⇒ | Communication Settings | ⇒ | TTL Res Time | Parameter Type — Numerical | |
|
|
| Factory Default — 0.00 | |||
This parameter sets the TTL response delay time. | ||||||
| ||||||
Changes made to this parameter require that the power be cycled (Off then On) | Changeable During Run — Yes | |||||
for the changes to take effect. |
|
| Minimum — 0.00 | |||
| ⇒ |
| ⇒ |
| ||
|
|
| Maximum — 2.00 | |||
|
|
| Units — Seconds |
62 | W7 ASD Installation and Operation Manual |