Toshiba W7 manual S1 Terminal, S10 Terminal, S11 Terminal

S1 Terminal					S11 Terminal
S1 Terminal
Program		Terminal Settings	Input Terminals	S1 Terminal	Parameter Type — Selection List
Assignment					Factory Default — Fire Speed
This parameter selects the functionality of the S1 discrete input terminal.					Changeable During Run — No
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S1 terminal to 1 of the 69 possible
functions that are listed in Table 6 on page 138.
S10 Terminal
Program		Terminal Settings	Input Terminals	S10 Terminal	Parameter Type — Selection List
Assignment					Factory Default — Unassigned
This parameter selects the functionality of the S10 discrete input terminal.					Changeable During Run — No
Note: The S10 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicomoption board the S10 terminal
settings will be stored in volatile memory. The terminal
settings will be lost if the system is powered down or reset.
	⇒		⇒⇒
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S10 terminal to 1 of the 69 possible
functions that are listed in Table 6 on page 138.
S11 Terminal
Program		Terminal Settings	Input Terminals	S11 Terminal	Parameter Type — Selection List
Assignment					Factory Default — Unassigned
This parameter⇒selects the functionality⇒⇒of the S11 discrete input terminal.
					Changeable During Run — No

Note: The⇒S11 input terminal may⇒⇒be used without the ASD-

Multicom option board.

Without the ASD-Multicomoption board the S11 terminal settings will be stored in volatile memory. The terminal settings will be lost if the system is powered down or reset.

In addition, the input terminal must be specified as Normally Open or

Normally Closed.

This parameter sets the programmable S11 terminal to 1 of the 69 possible functions that are listed in Table 6 on page 138.

W7 ASD Installation and Operation Manual 119