Toshiba W7 manual Emergency Off Mode Time, End Frequency, Error Detect Time

Emergency Off Mode						Error Detect Time
Emergency Off Mode
Program		Protection Settings Emergency Off Mode Selection				Parameter Type — Selection List
This parameter determines the method used to stop the motor in the event that						Factory Default — Coast Stop
an Emergency Off command is received.						Changeable During Run — No
This setting may also be associated with the FL terminals to allow the FL relay
to change states when an EOFF condition occurs by setting the FL terminal to
Fault FL (all).
Note: A supplemental emergency stopping system should be used
with the ASD. Emergency stopping should not be a task of
the ASD alone.
Settings:
Deceleration Stop
DC Injection Braking Stop
Coast Stop
Emergency Off Mode Time
Program	⇒	Protection Settings Emergency Off Mode Time				Parameter Type — Numerical
					⇒	Factory Default — 0.10
When DC Injection is used as a function of receiving an Emergency Off
command,⇒this parameter determines⇒the time that the DC Injection braking is						Changeable During Run — Yes
applied to the motor.
						Minimum — 0.00
						Maximum — 10.00
						Units — Seconds
End Frequency
Program	⇒	Special Control End Frequency				Parameter Type — Numerical
				⇒		Factory Default — 0.0
This parameter sets the lowest frequency that the ASD will recognize during
deceleration before the ASD goes to 0.0 Hz.						Changeable During Run — Yes
						Minimum — 0.0
						Maximum — 80.0
						Units — Hz
Error Detect Time
Program		Communication Settings Error Detect Time				Parameter Type — Numerical
This setting determines the length of time that an ASD is monitored for an						Factory Default — 200
error.						Changeable During Run — Yes
W7 ASD Installation⇒			and Operation Manual⇒
						Minimum — 0
						Maximum — 1000
						Units — Seconds
						71