● If the user selects < E n a b l e o p t i o n s > , the system incorporates the | changes | |||
requested and displays the message D I S C O N N E C T E D . If Autobaud | is | off, | the | |
user | must now press BREAK to return to Command Mode. If Autobaud | is | on, | the |
user | must press BREAK and RETURN to return to Command Mode. |
|
|
|
Note: If a user attempts to enable options during a “SAVE” operation by the system administrator, the message “options changed FAILED” will be displayed. The user will be returned to the top level of the Command Mode menu, and all change requests discarded. After waiting a few minutes, the user may try again to change his/her data port parameters.
Considerations
For those cases where a data terminal user accesses various data endpoints, each requiring option changes, the User Changeable Options feature simplifies the process of administering the data port to allow data call setup. A system administrator is not required to enter each change.
Interactions |
|
|
|
|
|
|
|
|
|
● Expert | Mode: | See | the | Expert | Mode feature | description | for | an | abbreviated method |
of accessing Command Mode menus. |
|
|
|
| |||||
Administration | Requirements |
|
|
|
|
|
| ||
● Data | Port |
|
|
|
|
|
|
|
|
A data | port must be administered to allow the | terminal | user | to | change options from | ||||
the Command Mode menu. If permission is denied, the user may view the current | |||||||||
option | settings | but | not | change | them. |
|
|
|
|
●AT&T STARLAN NETWORK Access
The User Changeable Options feature is not available for ports administered as STARLAN INTERFACE ports. Refer to the “STARLAN NETWORK Access” feature description for additional information.
