AT&T AT&T manual System Assign Primary Secondary Attendant

terminations on the rightmost two columns of buttons of the inactive console. Ringers disabled on an inactive console will be enabled on the active console for those trunks with dual appearances (appearances on both consoles). All other features on all buttons, including those on the associated Attendant Direct Extension Selector Console will continue to function normally even though the console is inactive.

Interactions

A DTAC cannot operate in the same system with a SLAC.

Refer to the Attendant Feature descriptions for information on other related features as listed in Table 2-E.

Administration Requirements

System:
● Assign	Primary	and Secondary		Attendant	Positions	(Vi)
● Display	attendant position number (first or				second)	(V2)
● Assign	number	of	rings before	unanswered	calls return to the Attendant Positional-
31) -Default =		5	rings

● Send DID calls to unassigned numbers to the Attendant Position (Yes, No) -Default

=Yes

●Send calls to Floating Personal Dial Codes that are not logged-in to the Attendant

Position (Yes, No) -Default = Yes

●Assign number of seconds before an unanswered Camped-On Call returns to the Attendant Console (1-120 seconds), or No Attendant Camp-On (0) - Default = 30 seconds.

Attendant Console: (Station Port)

● Voice terminal type = 309 (V2)

●Special Programmable Buttons:

—Night Service

—Position Busy

—Attendant Message Waiting (assigned by default).

Note: The following buttons are predefined on the Attendant Console and are not administrable:

–Alarm

—Return-On-Don’t-Answer

—Return-On-Busy

—Start

–Cancel

2-15