
The call from Carter has been split while the call is extended. After the attendant dials the desired PDC, screen 1 displays called party identification, and screen 2 remains unchanged:
&1397 Phelps, T 7
2344 Carter, M &
If the attendant now presses RELEASE, both screens go blank. If the attendant presses JOIN, the two parties and the console are connected together; screen 1 displays conference information:
CONFERENCE 3 7
Conference set up by attendant:
After the attendant has called all the conferees and connected them together on a LOOP button, screen l displays the type of call and the number of parties, including the console:
CONFERENCE 4 7
If the attendant releases, the screen goes blank.
Inspection Mode
Pressing the INSPECT button puts the console in the inspection mode. In this condition the console is unavailable to incoming calls and the attendant can get information about held calls, trunk availability, and numbers assigned to certain buttons. Pressing the INSPECT button a second time will restore the console to normal operation, as will a change of switchhook state
While the inspection mode is active, the attendant can press any of the following buttons to provide special information on display screen 1.
. Loop button where a call is ringing or on
. Direct Facility Access
. Repertory Dial, Automatic Intercom, DSS, Flex DSS, or Last Number