
COMMAND MODE
Allows data terminal users to originate data and voice calls and change (or view) their data port options.
(Refer also to the general description of the system’s data features in “Data Services Overview”; users who are familiar with Command Mode options should read the “Expert Mode” subsection. )
Command Mode supports digital data endpoints connected via Asynchronous Data Units (ADUs) to ports on a Data Line CP (TN726). Command Mode also supports, with certain restrictions, users of the STARLAN Interface Circuit Pack, ZTN84 (V2 only).
Command Mode is invoked from a data terminal in the idle
Terminal Optioned For Autobaud
Terminal Not Optioned For Autobaud
Enter Break followed by Return
Enter Break
The terminal then displays the Command Mode menu:
<Data call> <Voice call> <Options> <Hangup> (V2 only)
<place Data call> <Options> <Hangup> (V1 only)
Menu items are chosen either by positioning the cursor under the desired item (by typing “space” characters) and entering a Return, or by typing the
<Data call> or <place Data call>:
Refer to the “Data Terminal Dialing” feature description for information on how to dial from your terminal. Once a data call has been set up, either the “Disconnect/Recall Sequence” (see the Permissible Options, Table
<Voice call> (V2 only): |
|
|
| |
The data terminal user can originate a call | for an | data terminal | ||
to a remote terminal by | selecting <Voice call> and dialing the required digits. | Refer to the | ||
feature description | for a | complete description of this | feature. |