Programming Procedures
Program mode may be entered either by dialing a code (#4) or by moving the Test/Program switch to P (on voice terminals so equipped). If the code is used to enter program mode, the terminal remains in program mode until the user goes
Programming a number always removes the number that was previously stored in the same location. If a user wants to remove an old number and not replace it with a new one, “ 0“ should be entered in place of the number to be programmed.
To Program a Number by Using a Code:
1.Lift the handset and listen for dial tone.
2.Dial #4.
3.Dial the number you wish to program.
4.Either:
—press the FLEX DSS or REP DIAL button, o r
—dial the Personal Speed Dialing code (#20
to indicate where this number should be stored.
5.Listen for confirmation tone and dial tone.
6.Hang up.
To Program a Number by Using the Switch:
1. | Slide the switch on the left side of the voice terminal to P. |
2. | Lift the handset and dial the number you wish to program. |
3 . | Either: |
—press the FLEX DSS or REP DIAL button, o r
—dial the Personal Speed Dialing code
to indicate where this number should be stored.
4.Listen for confirmation tone and dial tone.
5.Hang up.
6.Slide the switch back to the midpoint between P and T.