Chapter 2: Installation 17

Making a direct connection to configure the network parameters.

On your Microsoft® Windows workstation, ensure that a terminal emulation program is installed. On servers running a UNIX-based operating system such as Solaris or Linux, make sure that a compatible terminal emulator such as Kermit or Minicom is installed.

To connect to the console port:

You can use a CAT 5 straight-through cable with RJ-45 connectors and the appropriate adaptor provided in the product box to assemble a console cable. All adaptors have an RJ-45 connector on one end and either a DB25 or DB9 male or female connector on the other end.

1.Connect the RJ-45 end of the cable to the port labeled Console on the console server.

2.Connect the adaptor end of the cable to the console port of your server or device.

3.Open your terminal emulation program, start a connection session, select an available COM port and enter the following console parameters.

Bits per second: 9600 bps

Data bits: 8

Parity: None

Stop bit: 1

Flow control: None

Console server serial port pin-out information

The following table provides the serial port pin-out information for the console server.

Table 2.1: ACS 5000 Console Server Serial Port Pin-out

Pin No.

Signal Name

Input/Output

1

RTS

OUT

2

DTR

OUT

3

TxD

OUT

4

GND

N/A

5

CTS

IN

6

RxD

IN

7

DCD

IN

8

DSR

IN

Page 25
Image 25
Avocent ACS 5000 manual To connect to the console port, Console server serial port pin-out information