iscsi profile-compellant
Configure the auto-detection of Dell Compellent arrays on a port.
S4820T
Syntax iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is
monitored.
S4820T
Syntax iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi
target port command.
Parameters tcp-
port-2...tcpport
- 16
Enter the tcp-port number of the iSCSI target ports. The
tcp-port-n is the TCP port number or a list of TCP port
numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860,
3260.
ip-address
(Optional)
Enter the ip-address that the iSCSI monitors. The ip-address
specifies the IP address of the iSCSI target.
iSCSI Optimization 1019