Command
Modes
CONFIGURATION
INTERFACE
Command
History Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage
Information A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map
command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.
priority-pgid
Assign 802.1p priority traffic to a priority group in a DCB map.
Syntax priority-pgid dot1p0_group-num dot1p1_group-num dot1p2_group-
num dot1p3_group-num dot1p4_group-num dot1p5_group-num
dot1p6_group-num dot1p7_group-num
Parameters dot1p0_group-
num
Enter the priority group number for each 802.1p class of
traffic in a DCB map.
dot1p1_group-
num
dot1p2_group-
num
594 Data Center Bridging (DCB)