Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information If you enter the bgp dampening command, the default values for half-life,
reuse, suppress, and max-suppress-time are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Route refresh is sent when you enable BGP dampening.
Related
Commands
show ip bgp dampened-paths — views the BGP paths.
bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
Syntax bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters value Enter a number to assign to routes as the degree of
preference for those routes. When routes are compared, the
higher the degree of preference or local preference value,
the more the route is preferred. The range is from 0 to
4294967295. The default is 100.
Defaults 100
Command
Modes
ROUTER BGP
Border Gateway Protocol 417