Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
priority-list
Configure the 802.1p priorities for the traffic on which you want to apply an ETS output policy.
Syntax priority-list value
To remove the priority list, use the no priority-list command.
Parameters value Enter the priority list value. Separate priority values with a
comma; specify a priority range with a dash; for example,
priority-list 3,5-7. The range is from 0 to 7.
Defaults none
Command
Modes
PRIORITY-GROUP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default:
• All 802.1p priorities are grouped in priority group 0.
• 100% of the port bandwidth is assigned to priority group 0. The complete
bandwidth is equally assigned to each priority class so that each class has 12 to
13%.
Data Center Bridging (DCB) 573