Parameters pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 or 2.
Defaults None
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
interfaces. It is also acts as defaults when the link-level flow control is enabled on
one or more interfaces.
Enables priority flow control or enhance transmission selection on interface.
Related
Commands
dcb <ets | pfc> enable — enable priority flow control or enhanced transmission
selection on interface.
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax description text
To remove the text description, use the no description command.
Parameters text Enter the description of the output policy. The maximum is
32 characters.
Defaults none
Command
Modes • DCB INPUT POLICY
• DCB OUTPUT POLICY
572 Data Center Bridging (DCB)