member-vlan
Specify the member VLAN identification numbers.
S4820T
Syntax member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters vlan-range Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10. Combination: 3, 4, 5-10, 8.
Defaults none
Command
Modes
CONFIGURATION (conf-frrp)
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
mode
Set the Master or Transit mode of the ring.
S4820T
Syntax mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Force10 Resilient Ring Protocol (FRRP) 725