Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information In the Dell Networking OS best path selection process, the path with the highest
weight value is preferred.
NOTE: In the Dell Networking OS best-path selection process, the path with
the highest weight value is preferred.
If you configure the set weight command in a route map applied to this
neighbor, the weight set in that command overrides the weight set in the
neighbor weight command.
Related
Commands
set weight — assigns a weight to all paths meeting the route map criteria.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
S4820T
Syntax network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map
map-name] command.
Parameters ip-address Enter an IP address in dotted decimal format of the network.
mask Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
route-map
map-name (OPTIONAL) Enter the keyword route-map then the name
of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
474 Border Gateway Protocol