management egress-interface-selection
To make configured application traffic egress through the management port instead of the front-end (FE)
port, enable and configure a management egress interface.
S4820T
Syntax management egress-interface-selection
To disable and remove management egress interface selection (EIS) configurations,
use the no management egress-interface-selection command.
Defaults None.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
show ip management-eis-route
Display the management routes used by EIS.
S4820T
Syntax show ip management-eis-route
Defaults None.
Command
Modes
EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2.(0.0) Introduced on the Z9000, S4810, and S4820T.
Example Dell#show ip management-eis-route
Destination Gateway State Route Source
----------- ------- ----- ------------
858 Interfaces