To delete an interface from a Port Channel, use the no channel-member
interface command.
Parameters interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Not configured.
Command
Modes
INTERFACE PORTCHANNEL
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information Use the interface port-channel command to access this command.
You cannot add an interface to a Port Channel if the interface contains an IP
address in its configuration. Only the shutdown, description, mtu, and ip mtu
commands can be configured on an interface if it is added to a Port Channel. The
mtu and ip mtu commands are only available when the chassis is in Jumbo mode.
Link MTU and IP MTU considerations for Port Channels are:
Interfaces 861