Usage
Information A new policy command is introduced in order to attach the Link Bandwidth
extended community only to the prefixes that are received from a neighbor that
satisfy the desired conditions. This command is relevant for both inbound as well
as outbound policy handling (for received prefixes). Also, there is no change to the
set of supported conditions or filters.
During configuration, the bandwidth is specified in Mbps, not in bytes/second.
While creating the actual LB extended community, the system will attach the AS
number and encode the bandwidth in floating point format.
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv4 address on the system.

S4820T

Syntax show capture bgp-pdu neighbor ipv4-address
Parameters ipv4-address Enter the IPv4 address (in dotted decimal format) of the BGP
address to display packet information for that address.
Command
Modes
EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced.
Example Dell(conf-router_bgp)#show capture bgp-pdu neighbor 20.20.20.2
Incoming packet capture enabled for BGP neighbor 20.20.20.2
Available buffer size 40958758, 26 packet(s) captured using
680 bytes
PDU[1] : len 101, captured 00:34:51 ago
ffffffff ffffffff ffffffff ffffffff 00650100 00000013
00000000
482 Border Gateway Protocol