pfc mode on
Enable the PFC configuration on the port so that the priorities are included in DCBX negotiation with peer
PFC devices.
Syntax pfc mode on
To disable the PFC configuration, use the no pfc mode on command.
Defaults PFC mode is on.
Command
Modes
DCB MAP
Command
History Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the MXL 10/40GbE Switch with the FC Flex
IO module.
Usage
Information By applying a DCB input policy with PFC enabled, you enable PFC operation on
ingress port traffic. To achieve complete lossless handling of traffic, also enable
PFC on all DCB egress ports or configure the dot1p priority-queue assignment of
PFC priorities to lossless queues (refer to pfc no-drop queues).
To disable PFC operation on an interface, enter the no pfc mode on command in
DCB Input Policy Configuration mode. PFC is enabled and disabled as global DCB
operation is enabled (dcb-enable) or disabled (no dcb-enable).
You cannot enable PFC and link-level flow control at the same time on an
interface.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
596 Data Center Bridging (DCB)