Command
Modes
VLT DOMAIN PROXY GW LLDP
Command
History Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage
Information
The VLT port channel interface which is connecting to the remote VLT domain
must be configured as peer-domain-link. Configure the VLANs that needs to be
excluded from VLT Proxy Gateway.
Example Dell(conf)#vlt-domain 1
Dell(conf-vlt-domain)#proxy-gateway lldp
Dell(conf-vlt-domain-proxy-gw-lldp)#peer-domain-link port-
channel 20 exclude-vlan 3
proxy-gateway peer-timeout Enables the VLT node to timeout the transmission of peer’s mac address, when the VLT peer is down.
S4820T
Syntax [no] peer-timeout value
Parameters value Enter the timeout value in seconds. The range is from 1 to
65535.
Command
Modes
VLT DOMAIN PROXY GW LLDP
Command
History Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Removed the default value on the S-Series and Z-Series.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
When a VLT peer goes down, the local VLT node must stop sending its peer’s MAC
address. If this timeout is configured, the local VLT node will send its peer's MAC
address, till the timer expires. By default this timer value is infinity. This timer comes
into play, only when the vlt-peer-mac transmit is enabled. Square VLT Topology
with single link connecting to the remote peers, is a typical use case for this
configuration.
VLT Proxy Gateway 1869