Version Description
9.2.0.0 Introduced on the Z9000, S4820T, and S4810.
Usage
Information This command provides the flexibility to fine-tune the timer values based on
individual interface needs when you configure ipv6 ospf BFD in CONFIGURATION
mode. Any timer values specified with this command overrides timers set using the
bfd all-neighbors command. Using the no form of this command does not
disable BFD if you configure BFD in CONFIGURATION mode.
To disable BFD on a specific interface while you configure BFD in
CONFIGURATION mode, use the keyword disable.
ipv6 ospf cost
Explicitly specify the cost of sending a packet on an interface.
S4820T
Syntax ipv6 ospf interface-cost
Parameters interface-cost Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
Defaults Default cost based on the bandwidth.
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage
Information In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost is calculated as:
• GigabitEthernet—Default cost is 1
1358 Open Shortest Path First (OSPFv2 and OSPFv3)