Example Dell#show ipv6 nd ra-guard policy test
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 1
match ra ipv6-access-list access
other-config-flag on
router-preference maximum medium
trusted-port
Interfaces :
Te 1/1
Dell#
Related
Commands •ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
•ipv6 nd ra-guard policy — Defines the RA guard policy name and enter the RA
guard policy list configuration mode.
•device-role — Specifies the role of the device attached to the port.
•hop-limit — Enables the verification of the advertised hop count limit.
•mtu — Sets the maximum transmission unit (MTU) value.
•other-config-flag — Enables the verification of the advertised other
configuration parameter.
•reachable-time — Sets the advertised reachability time.
•retrans-timer — Sets the advertised retransmission time.
•router-preference maximum — Enables the verification of the advertised default
router preference (DRP) value.
•trusted-port — Applies the policy to trusted ports.
•ipv6 nd raguard attach-policy — Applies the IPv6 RA guard to a specific
interface.
trusted-port
Allow bypassing the configured RA guard validation and forwards the RA packets received on the
interface, which has the trusted port policy attached.
Syntax trusted-port
To reset the policy applied to the trusted port, use the no trusted-port
command.
Defaults none
Command
Modes
POLICY LIST CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1238 Neighbor Discovery Protocol (NDP)