Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Maximum range of the Hello interval value is changed to
18000. Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
Usage
Information
If you have configured the hello interval value to be greater than 18000, you must
first reset that value to be less than or equal to 18000 before upload. Otherwise,
the command execution fails during bootup and the hello interval value is set to
the default value.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
NOTE: The IGMP query-max-resp-time value must be less than the IGMP query-interval value.
Syntax ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
768 Internet Group Management Protocol (IGMP)