Version Description
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale. Prior
releases supported 2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
When creating an interface range, interfaces appear in the order they are entered;
they are not sorted. The command verifies that interfaces are present (physical) or
configured (logical).
Important Points to Remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a
warning message.
• The interface range prompt includes interface types with slot/port
information for valid interfaces. The prompt allows for a maximum of 32
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
Example (Bulk) Dell(conf)#interface range tengigbitethernet 2/1 - 11,
fortyGigbE 3/3, tengigbitethernet 3/10
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
(Multiple Ports) Dell(conf)#interface range tengigabitethernet 2/10 - 23,
tengigabitethernet 2/12 - 17
Dell(conf-if-range-te-2/10-23)#
Example
(Overlapping
Ports)
Dell(conf)#interface range tengigabitethernet 2/3 - 11,
tengigabitethernet 2/3 - 23
Dell(conf-if-range-te-2/3-23)#
Usage
Information Only VLAN and port-channel interfaces created using the interface vlan and
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature of
806 Interfaces