ipv6 access-list
Configure an access list based on IPv6 addresses or protocols.
S4820T
Syntax ipv6 access-list access-list-name cpu-qos {permit | deny}
ospfv3
To delete an access list, use the no ipv6 access-list access-list-name
command.
Parameters access-list-
name
Enter the access list name as a string, up to 140 characters.
cpu-qos Enter the keyword cpu-qos to assign this ACL to control
plane traffic only (CoPP).
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition.
ospfv3 Specify that this ACL is for OSPFv3 control plane traffic
Defaults All access lists contain an implicit “deny any”; that is, if no match occurs, the packet
is dropped.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for CoPP for OSPFv3 on the S4810, S4820T,
S6000, and Z9000 platforms.
9.0.2.0 Introduced on the S6000
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
IPv6 Access Control Lists (IPv6 ACLs) 981