Dell 9.8(0.0) - page 495

Parameters vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of
the VRF to view routes that are affected by a specific
community list corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view information related only to ipv4
multicast routes.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 followed by the
keyword unicast to view information related only to ipv4
unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to view information related only to ipv6
unicast routes.
Command
Modes • EXEC
• EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information To determine a BGP session flap, both a route-down event and a subsequent
route-up event corresponding to a single route are considered. As a result, a flap
event is penalized only one time during the route-down event. The subsequent
route-up event corresponding to the same route is not considered as a flap and is
not penalized.
The history paths that the show ip bgp command displays contain only the prefix
and the next-hop information. The next-hop information shows the ip address of
the neighbor. It does not show the actual next-hop details.
Border Gateway Protocol 495