Dell 9.8(0.0) - page 1304

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.9.1.0 Added support for VRF.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
You must have an IP address assigned to an interface to enter ROUTER OSPF mode
and configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF
Process ID again in the system.
Example Dell(conf)#router ospf 2
Dell(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S4820T
Syntax show config
Command
Modes
ROUTER OSPF
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
1304 Open Shortest Path First (OSPFv2 and OSPFv3)