Dell 9.8(0.0) - page 799

• For a null interface, enter the keyword null then the
slot/port information. The Null interface number is 0.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to1. The port range
is 0.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
range (Optional) Enter the keyword range to configure an
interface range.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added the support for interfaces.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage
Information You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an
IP address or switchport. To place an interface in Layer 2 mode, ensure that the
Interfaces 799