Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage
Information
If you want the interface to receive both versions of RIP, use the ip rip receive
version 1 2 command.
Related
Commands ip rip send version — sets the RIP version for sending RIP traffic on an interface.
version — sets the RIP version the switch software uses.
ip rip send version
To send a specific version of RIP, set the interface. The version you set on the interface overrides the
version command in ROUTER RIP mode.
S4820T
Syntax ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters 1(OPTIONAL) Enter the number 1 for RIP version 1. The
default is RIP version 1.
2(OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1
Command
Modes
INTERFACE
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
1522 Routing Information Protocol (RIP)