hello-time — changes the time interval between BPDUs.
protocol spanning-tree rstp
To configure RSTP, enter RSTP mode.
Syntax protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the
system, use the no disable command from RSTP mode.
Example Dell(conf)#protocol spanning-tree rstp
Dell(config-rstp)##no disable
Related
Commands
disable — disables RSTP globally on the system.
Rapid Spanning Tree Protocol (RSTP) 1565