interface’s configuration does not contain an IP address and enter the switchport
command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the no interface
tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example Dell(conf)#int tengigabitethernet 1/10
Dell(conf-if-te-1/10)#exit
Dell(conf)#
Related
Commands interface loopback — configures a Loopback interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
show interfaces — displays the interface configuration.
interface group
Create or delete group of VLANs with a single command. You can also use this command to apply a set
of configurations on a group of interfaces.
S4820T
Syntax interface group [fortyGigE slot/port { - port }|
tengigabitethernet slot/port { - port } | vlan vlanid {-
vlanid } ]
To delete a range of VLANs, use the following command: no interface group
vlan vlanid {- vlanid}
Parameters interface,
interface,... Enter the keywords interface group and one of the
interfaces — slot/port or VLAN number. Select the range of
interfaces for bulk configuration. Spaces are not required
between the commas. Comma-separated ranges can
include VLANs and physical interfaces.
Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
800 Interfaces