Command
Modes
ROUTER BGP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information CAUTION: Dell Networking recommends not changing the administrative
distance of internal routes. Changing the administrative distances may cause
routing table inconsistencies.
The higher the administrative distance assigned to a route means that your
confidence in that route is low. Routes assigned an administrative distance of 255
are not installed in the routing table. Routes from confederations are treated as
internal BGP routes.
Related
Commands router bgp — enters ROUTER mode on the switch.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S4820T
Syntax show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6
unicast] dampened-paths
Parameters vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of
the VRF to view routes that are affected by a specific
community list corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword multicast to view information related only to ipv4
multicast routes.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 followed by the
keyword unicast to view information related only to ipv4
unicast routes.
526 Border Gateway Protocol