neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
S4820T
Syntax neighbor [ip-address | peer-group-name] add-path [send |
receive | both] path-count
Parameters ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
send Enter the keyword send to indicate that the system sends
multiple paths to peers.
receive Enter the keyword receive to indicate that the system
accepts multiple paths from peers.
both Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
path-count Enter the number paths supported. The range is from 2 to
64.
Defaults none
Command
Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Related
Commands
bgp add-path — allows the advertisement of multiple paths for the same address
prefix without the new paths implicitly replacing any previous ones.
446 Border Gateway Protocol