Parameters ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to send a COMMUNITY
attribute to all routers within the peer group.
extended (OPTIONAL) Enter the keyword extended to send extended
community attribute.
standard (OPTIONAL) Enter the keyword standard to send standard
community attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command
Modes
ROUTER BGP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version Description
9.7(0.0) Introduced on the S6000–ON.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
To configure a COMMUNITY attribute, use the set community command in
ROUTE-MAP mode.
In order that settings corresponding to the neighbor send-community
command take effect, you must execute the clear ip bgp command
immediately after you execute the neighbor send-community command.
If you do not set any of the optional parameters (standard or extended), then both
standard as well as extended attributes are sent. If you set either the standard or
extended parameter, only the attribute that is specified is sent.
neighbor shutdown
Disable a BGP neighbor or peer group.
S4820T
Syntax neighbor {ip-address | peer-group-name} shutdown
468 Border Gateway Protocol