Dell 9.8(0.0) - page 274

in which you are creating the rule is applied to the monitored

interface.

NOTE: For more information, refer to the “Flow-based

Monitoring” section in the Port Monitoring chapter of the

Dell Networking OS Configuration Guide.

no-drop Enter the keywords no-drop to match only the forwarded

packets.

Defaults Not configured

Command

Modes

CONFIGURATION-MAC ACCESS LIST-STANDARD

Command

History This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Added the no-drop parameter.

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 Added the monitor option.

6.1.1.0 Introduced on the E-Series.

Usage

Information When you use the log option, the CP processor logs details about the packets that

match. Depending on how many packets match the log entry and at what rate, the

CP may become busy as it has to log these packets’ details.

NOTE: When you configure the ACL logging and byte counters

simultaneously, byte counters may display an incorrect value. Configure

packet counters with logging instead.

Commands deny — configures a filter to drop packets.

permit — configures a filter to forward packets.

274 Access Control Lists (ACL)