Parameters ipv4-address |
ipv6-address
Enter the IP address of the neighbor for which you want to
start storing inbound routing updates.
peer-group-
name
Enter the name of the peer group for which you want to start
storing inbound routing updates.
Defaults Disabled.
Command
Modes
ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address
families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage
Information
This command enables soft-reconfiguration for the specified BGP neighbor. BGP
stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
IPv6 MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables the multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (AS). FTOS MBGP is
implemented as per IETF RFC 1858.
Border Gateway Protocol 537