• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults The IP address assigned to the management interface is the default.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable this snmp-server trap-source command, configure an IP address
on the interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server community — sets the community string.
snmp-server userConfigure a new user to an SNMP group.
Syntax snmp-server user name {group_name remote ip-address vrf vrf-
name udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5
| sha} auth-password] [priv {des56 | aes128} priv password]
Simple Network Management Protocol (SNMP) and Syslog 1711