Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage
Information If you configure the set next-hop command, its configuration takes precedence
over the neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface’s IP address
(either Loopback or physical), the software declares the route unreachable.
Related
Commands match ip next-hop — redistributes routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
Syntax set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the no set origin command.
Parameters egp Enter the keyword egp to set routes originating from outside
the local AS.
igp Enter the keyword igp to set routes originating within the
same AS.
incomplete Enter the keyword incomplete to set routes with
incomplete routing information.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
314 Access Control Lists (ACL)