Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
std-access-list Specify the standard IP access list that contains the mapping
rules for multicast groups.
source-address Specify the multicast source address to which the groups are
mapped.
Command
Modes
CONFIGURATION
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF and Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.7.1.0 Introduced on the E-Series.
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
in the IGMP groups. You may not use extended access lists with this command.
When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard — creates a standard access list to filter based on IP address.
ip igmp versionManually set the version of the router to IGMPv2 or IGMPv3.
S4820T
Syntax ip igmp version {2 | 3}
770 Internet Group Management Protocol (IGMP)