Efficient Networks 107-0001-000 manual Remote delatmsnap, Remote delbridge, ATM forum encoding

Efficient Networks® Router family	Chapter 6: Remote Commands
Command Line Interface Guide

remote delatmsnap

This command deletes an ATM mapping set by the remote setatmnsap command, page 40.

Mgmt Class

Network (R/W)

Input Format

remote delatmfasp atmf e164 partial full <nsap> <remotename>

Parameters

atmf	ATM forum encoding.
E164	ITU E164 encoding.
partial	The MAC address of the router is substituted for octets 2-7 of the NSAP.
full	No change is made to the specified NSAP.
<nsnap>a	NSAP

aspecified as 40 hex digits or 20 octets (2-digit pairs separated by colons

Response

Command prompt.

remote delbridge

Removes the designation of the remote router entry as the default bridging destination. (Default bridging destinations are defined using the remote addbridge command.) To see the bridge settings for a remote entry, use the remote listbridge command.

To remove a designation as the default bridging destination for a specific MAC address, specify that address on the command. The entry is then removed from the bridging table. To see the entries in the bridging table, use the bi list command.

Mgmt Class

Network (R/W)

Input Format

remote delbridge * <mac_addr> <remotename>

Efficient Networks® Page 6-17