Efficient Networks 107-0001-000 manual Qos set parameter policy name

SpeedStream® Router family	Chapter 20: QoS Commands
Command Line Interface Guide

qos set

Defines one or more parameters of a QoS policy. To view the current configuration of a policy, use the qos list <policy name> command.

NOTE:

The QoS policy must exist (created with the qos append or qos insert commands) and be disabled prior to configuration.

Mgmt Class

Network (R/W)

Input Format

qos set [<parameter>] <policy name>

Parameters

Multiple parameters can be entered in the same command for a single QoS policy; the sequence of parameters in not essential. The parameters are listed below.

-sa <source address>a off <start address>[:end address>]

Specifies the source address or range of addresses. Off will disable source-address checking.

-da <destination address>a off <start address>[:<end address>]

Specifies the destination address or range of addresses. Off will disable destination-address checking.

-p <protocol> off <protocol number>b tcp udp

Specifies the protocol by protocol number or explicitly TCP or UDP. Entering off will dis-

able the protocol check.

-sp <source port>c off <start port number>[:<end port number>]

Specifies the source port or range of ports by number or specific application. Off dis- ables the port check.

-dp <destination port> off <start port number>[:<end port number>] off ftp telnet smtp http snmp tftp dns login rsh h323 t120

Specifies the destination port or range of ports by number or specific application. Off disables the port check.

-pr <priority> high medium normal low

Specifies the priority, with normal the default value.

-ic <incoming code point> off <code point>

Efficient Networks® Page 20-11