Efficient Networks 107-0001-000 manual Remote disbridge

Efficient Networks® Router family		Chapter 6: Remote Commands
Command Line Interface Guide
	Table 6-1: Remote Command Listing (Cont.)
	Command	Function
	remote disauthen	This command is intended for situations where third-
		party routers cannot be authenticated; the target router
		will not attempt to authenticate the remote router.
	remote disbridge	Disables bridging from the target router to the remote
		router.
	remote enaauthen	Initiates the target router authentication negotiation as
		defined in the remote router’s database.
	remote enable	Enables use of an entry in the remote router database.
	remote enabridge	Enables bridging from the target router to the remote
		router.
	remote ipfilter	Manages the IP filters on the WAN interface.
	remote list	Lists the remote router entry (or all the entries) in the re-
		mote router database.
	remote listbridge	Lists the current bridge settings for the specified remote
		router entry.
	remote listiproutes	Lists IP information for a remote router or, if the router
		name is omitted, for all routers in the remote router da-
		tabase.
	remote listipxroutes	Lists all network IPX route addresses defined for the
		LAN connected beyond the remote router.
	remote listipxsaps	Lists all services defined for the LAN connected beyond
		the remote router.
	remote listphones	Lists the PVC numbers available for connecting to the
		remote router.
	remote restart	Stops the current active session and starts a new active
		session for a remote.
	remote setatmnsap	RFC1577 (Classical IP over ATM) specifies a mecha-
		nism to map an ATM Name (called an SNAP) to a PVC.
	remote setauthen	Sets the authentication protocol used communicate with
		the remote router.
	remote setbod	Sets the bandwidth on demand (BOD) management op-
		tion for a DOD (dial on demand) connection, that is, a
		connection where the link goes up and down.
	remote setbroptions	Sets controls on bridging for the remote router entry.
	remote setbwthresh	Sets the bandwidth threshold for a DOD (dial on de-
		mand) connection, that is, a connection where the link
		goes up and down.

Efficient Networks® Page 6-3