Efficient Networks 107-0001-000 manual Dual-Ethernet Router ETH Commands

Efficient Networks® Router family	Chapter 7: WAN Interface Commands
Command Line Interface Guide

Dual-Ethernet Router (ETH) Commands

The following Ethernet commands are used to manage the Ethernet interfaces of the Dual-Ethernet (Ethernet-to-Ethernet) router and thus are specific to that type of router only. For the other Ethernet commands, see Chapter 5, Ethernet Interface Commands.

The Dual-Ethernet router has two interfaces:

•ETH/0Hub with four 10Base-T connectors

•ETH/1Single 10Base-T connector

This Dual-Ethernet router may be configured via the Web Browser GUI or from the Command Line Interface (CLI). To set up any DHCP options and to configure optional features like IP filtering, you must use the CLI.

If using the Boot from Network option from the boot menu to perform a boot code update, the boot request is sent from the ETH/0 interface only.

The Dual-Ethernet Router commands found in this section include:

Table 7-4: Dual Ethernet Router Command Listing

Command	Function
eth br enable	Enables bridging in a Dual-Ethernet environment.
eth br disable	Disables bridging in a Dual-Ethernet environment.
eth br options	Sets controls on bridging for the Ethernet interface.

Efficient Networks® Page 7-13