Efficient Networks 107-0001-000 manual Enables a defined IPSec security association en Try

Chapter 12: IKE/IPsec Commands		Efficient Networks® Router family
		Command Line Interface Guide
	Table 12-1: Internet Key Exchange Command Listing (Cont.)
	Command	Function
	ipsec enable	Enables a defined IPSec security association en-
		try.
	ipsec flush	Clears all IPSec definitions.
	ipsec list	Lists one or all of the IPSec security association
		(SA) entries.
	ipsec set authentication	Selects authentication for the IPSec SA using ei-
		ther SHA-1 (Secure Hashing Algorithm 1) or MD5
		(Message Digest 5).
	ipsec set authkey	Specifies the authentication key for the IPSec se-
		curity authentication (SA).
	ipsec set direction	Defines the direction of the IPSec security authen-
		tication (SA).
	ipsec set compression	Selects either LZ compression or no compression
		for the IPSec security authentication (SA).
	ipsec set enckey	Specifies the encryption key for the IPSec security
		authentication (SA).
	ipsec set encryption	Selects the method of encryption used for the IP-
		Sec security authentication (SA): no encryption,
		DES (56-bit) encryption, or 3DES (168-bit) encryp-
		tion.
	ipsec set gateway	Defines the IP address of the IP gateway of the IP-
		Sec security authentication (SA).
	ipsec set ident	Specifies the identifier (SPID) for the IPSec tunnel.
	ipsec set mode	Selects the encapsulation mode (tunnel or trans-
		port) for the SA.
	ipsec set service	Selects the authentication and/or encryption ser-
		vices used for the IPSec SA.

Page 12-4 Efficient Networks®