Efficient Networks 107-0001-000 manual Remote setbwthresh, Remote setBWthresh threshold remotename

Chapter 6: Remote Commands	Efficient Networks® Router family
	Command Line Interface Guide

remote setbwthresh

Sets the bandwidth threshold for a DOD (dial on demand) connection, that is, a connection where the link goes up and down. These links include those for ISDN, L2TP tunnels, IPSec tunnels, and dial backup.

The threshold is used in bandwidth on demand management. Initially, a call is activated on one B-channel. When bandwidth utilization reaches the bandwidth threshold, the second B-channel is activated. (The additional channel is available if the maximum links was set to 2 by a remote setmaxline command.)

Both channel are utilized until the bandwidth utilization drops below the threshold. The default is 0% utilization, in which case, both channels are always used for data transmission.

If you wish, you can have the bandwidth threshold apply only to incoming or outgoing traffic; see the remote setbod command.

Mgmt Class

Voice (R/W)

Input Format

remote setBWthresh <threshold> <remotename>

Parameters

<threshold>	Percentage of bandwidth utilization (0 through 100). The
	default is 0, in which case, whenever data transmission
	occurs, the maximum number of links is allocated.
<remotename>a	Name of the remote router.

aASCII string

Response

Command prompt.

Page 6-44 Efficient Networks®