Efficient Networks 107-0001-000 manual Atm pcr cells/second

Chapter 7: WAN Interface Commands	Efficient Networks® Router family
	Command Line Interface Guide

atm pcr

Sets the speed of the ATM link in cells per second.

The default upstream speed is 768 cells/second. Generally, your Network Service Provider should provide you with your speed value. If your service provider states your speed value in kilobits per second, enter the value using the atm speed command.

NOTE:

The speed value entered may not be the actual upstream speed attained. When the command changes the processor clocks, only certain discrete values are allowed. The speed achieved is the allowed speed value that is equal to or the next lower value to the value entered (see the example below).

Mgmt Class

Network (R/W)

Input Format

atm pcr [cells/second]

Parameters

***	When entered with no parameters, the current upstream speed is
	displayed.

<cells/second>a Upstream speed requested in cells/second.

aInteger, 294-18867

Example

The following command requests the current speed.

-> atm pcr 1200

ATM Upstream Rate: 500 Kb/sec or 1179 cells/sec

Response

Typical response when entered with no parameter.

-> atm pcr

ATM Upstream Rate: 326 Kb/sec or 768 cells/sec

Page 7-6 Efficient Networks®