Efficient Networks 107-0001-000 manual System addtelnetfilter

Efficient Networks® Router family	Chapter 4: System Commands
Command Line Interface Guide

system addtelnetfilter

Validates Telnet clients by defining a range of IP addresses that are allowed to access the router via Telnet. The mode is off by default. For more information, refer to

”Controlling Remote Management” on page 5-15of the Technical Reference Guide.

NOTE:

This command does not require a reboot and is effective immediately.

NOTE:

To list the range of allowed clients, use the system list command. To delete addresses from the Telnet filter, use the system deltelnetfilter command.

Mgmt Class

Security (R/W)

Input Format

system addtelnetfilter <first ip addr> [<last ip addr>] lan

Parameters

<first ipaddr>a First IP address of the client range. <last ipaddr>a Last IP address of the client range.b

lan Local Ethernet LAN.

aDotted-decimal notation

bMay be omitted if the range contains only one IP address.

Response

Command prompt.

Efficient Networks® Page 4-15